A minimum fee of $25.00 inc gst applies for up to 15 minutes and is then charged at $1.00 inc gst per minute thereafter. *Please Note – North East Security offer additional technical support over the phone if required. Enter USER CODE to silence beeping keypad. This will perform a Battery, Communicator and Siren test. Simply press the CHIME and ON, your keypad and this will activate it. If you have a zone allocated to DOOR CHIME (would have been arranged when alarm was installed, however can be added by your technician), you are able to initiate this function to let you know when a door has been opened. See list and instructions above, then enter # to exit this feature To silence the keypad, input USER CODE a second time and then enter * then 2 to display fault. If FAULT displays, refer to chart below then enter # to exit featureīEEPING SOUND – If plug pack in unplugged or the mains POWER is disconnected the keypad will SOUND (Beep) Press * then 2 – One or more zones will light If no other sector to isolate then press # To display sectors that casued last alarm conditionĮnter BYPASS then USER CODE – Bypass light will flashĮnter sector (two digit) e.g 03 to isolate sector 3Įnter BYPASS again, followed by next sector to isolate or Go on ebay and buy another keypad (NX-1324) that has the default password set.Keypad Instructions & Faults DAS/Hills Alarm PanelĮnsure READY light is on (All areas are sealed) It immediately beeps so *+ any number will not work. Using the password 1234 does not work, and when I try to hit *5 to be able to type in the installer code 9713.

Blinking Armed is telling me there has been an alarm during the previous arm cycle. Whenever I plug the power back in “Armed” and “5” will be blinking.

I ran into the laundry room to disconnect the power to the box to kill the alarm. Then I opened up a window which triggered the alarm to go off. I must have hit a button on it because I somehow armed it when I plugged the alarm module back in. My issues started when I removed the alarm from the wall to paint. It would make a chime noise and I was perfectly happy

I’ve been using the alarm as basically a chime whenever front door or garage door was open. Hello I recently moved into a house that the old owner did not “remember” or provide the pin to the alarm. Keypad: Networx Caddx Controls model NX-1324

Networx keypad instructions